Lemon Rx DSMP/X 7-Channel With Stabilizer PLUS (Top Pin) (DSMX/DSM2 Compatible)

Regular price $25.83


A simple to use stabilizer with auto leveling capability with extremely minimum settings / calibration required. Designed for beginner, FPV flyer or even advanced pilots who needs an extra safety feature under unexpected circumstance. Lemon Rx engineers had been spending months in optimizing stabilization control stratergy along with many flight tests by experienced pilots alloverthe world to come up an excpetionallyreliable and easy to use stabilizer (namely stabilizer PLUS). The otpmized control stratergy allow the stabilizer to work just about any planes with almost no complex tuning and minmal setup required that just take a few seconds to complete.

Contain all capabilities of the popular Lemon Rx stabilizer with simliar setup / interface
Auto-level (beginner / advanced) / gyro /no stabilization
4 orientations installation allowed with auto-detect feature (refer to user manual for full instruction)
Allow the use of all 7-channel even when stabilization is enabled
All channels failsafe capability (this means that you can even set the plane in obriting in the event of transmitter failure by setting stabilizer as auto-level with bank angle under failsafe)
Proprietary control algorithum ensure minimal user setup and extreme relability for different type of planes
Offset adjustments due to imperfect mechnical installation / servo linkage with a flip of switches
Optionally gear channel can be used to remotely control stabilization mode in either auto-level / gyro / no stabilization
Spektrum owner with DX5 is capable of using gear channel to choose either auto-level and no stabilization or gyro and no stabilization
Remote master gain on-the-fly adjustment on AUX3


Stabilizer PLUS with DSMP/X 7-Channel Full Range Receiver(Top Pin)

Number of Channel:

Proprietary DSMP/X (DSMX and DSM2 compatible with auto detection of both modes)

2.4 GHz

37(L) x 28(W) x 9(H) mm


Voltage Range:
3.45 - 7.2V

User Manual

Using the Stabilizer PLUS for the first time (hardware reset with most basic setup. Gear channel for mode changing with auto-level in beginner mode.)

See user manual for advanced setup with various functions. Below is the most simple instruction to guranteed the activation of auto-level / gyro / no stabilization with the use of 3-positions gear channel.

Insert bind plug horizontally between aileron and rudder to guranteed hardware reset of any unwanted settings set perviously and restore to factory default.
Provide power. When 4 LEDs flashes sequentially, remove power.
Set J4 to J6 accordingly. (Eg. J4 and J5 on with fixed wing aicraft with no dual aileron.)
Mount stabilizer PLUS mounted on a plane at its normal position (bottom of stabilizer PLUS is towarding ground at plane's normal flying position)
Bind stabilizer PLUS
Remove bind plug and wait until LEDs flashes complete and remove bind plug
Change gear channel to obesrve the changes of control mode with auto-level / gyro / no stabilization
Set J1 to J3 accordingly to adjust for cor